Clip parameters -20 – PIONEERPOS AT Commands G24-LC User Manual
Page 84
Call Control
3-20
G24-L AT Commands Reference Manual
April 15, 2008
The following table shows the +CLIP parameters
.
Example
AT+CLIP=?
+CLIP: (0,1)
//CLI presentation is disabled by the G24-L (0) and is enabled by the
network (1)
OK
AT+CLIP=1
OK
Example +CLIP indication:
(…incoming call…)
RING
+CLIP: "2173845400",129,,128,"Doe John",0
Example +CLIP indication with restricted CLI:
AT+CRC=1
OK
(…incoming call…, caller restricted the CLI presentation (used AT+CLIR)…)
+CRING: VOICE
+CLIP: "",128,,128,"",1
Table 3-8: +CLIP Parameters
<Parameter>
Description
<n>
Enables/disables the CLI presentation indication after the ring indication:
0
Disable CLI presentation
1
Enable CLI presentation
The default is 0.
<m>
Shows the subscriber CLIP service status in the network:
0
CLIP not provisioned
1 CLIP
provisioned
2
Unknown (for example, no network and so on)
<"number">
Calling line number. The number format is specified by <type>.
<type>
Type of address octet in integer format:
145
Default when the dialing string includes the international access code character
"+".
129
Default when making a local call.
128
Type of number is unknown (usually the output when the number itself is
unknown).
<subaddr>
NULL, field not used (String type subaddress of format specified by <satype>)
<satype>
Field not used. Value is always 128 (unknown) - type of sub address octet in integer
format.
<"alpha">
Name of the calling party (if provided by the network or if the number is found in the
G24-L phone books).
<CLI validity>
The Validity of the Calling Line Identity presentation:
0
CLI valid.
1
CLI has been withheld by the originator.
2
CLI is not available due to networking problems or limitations of the
originating network.