Nortel Networks NN43001-314 - Manual (Page 194)

194 Adding a Branch Office
• Emergency Services Access (ESA) package 329
• Virtual Office (VIRTUAL_OFFICE) package 382 and M3900 Phase III
Virtual Office Enhancement (VIR_OFF_ENH) package 387. These
packages are optional; they are required only for Virtual Office
functionality.
• BMG package 390
• IP Peer H.323 Trunk (H323_VTRK) package 399. This package is
optional; it is required for H.323 functionality. The packaging for package
399 also includes package 184.
ATTENTION
These packages are automatically enabled in the Branch Office software.
The Branch Office feature also requires the SIP Gateway and Converged
Desktop (SIP) package 406 for SIP. This package may or may not be
automatically enabled in the Branch Office software, depending on the
region in which the software is used.
When using Set-Based Installation at the MG 1000B, install the following:
• Set Relocation (SR) package 53
• Flexible Feature Code (FFC) package 139
• Automatic Installation (AINS) package 200
The feature packages listed above are automatically enabled in the Branch
Office software.
If the main office is equipped with Location Code Expansion (LOCX)
package 400, the Branch Office must also have this package. Refer to ISDN
Primary Rate Interface Fundamentals (NN43001-569).
The keycodes used to install software at the Branch Office differ from those
used to install software at the main office.
Implementation summary
To prepare for a Branch Office, refer to the Communication Server 1000E:
Planning and Engineering (NN43041-220) NTP. This contains important
electrical information and safety guidelines.
Follow these steps to implement the CS 1000 Release 5.0 Branch Office:
Step Action
1 At the main office:
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.