Nortel Networks NN43001-314 - Manual (Page 230)

230 MG 1000B platform hardware installation
Preparing for rack-mounting
Procedure 14
Preparing the Signaling Server for rack-mounting
Step Action
The Front Mount Bracket assembly is not intended for use as a slide rail
system. The Signaling Server must be firmly attached to the rack.
1 Make sure the Signaling Server is not plugged into an electrical
outlet.
2 Align the end of the rail (A in Figure 75 "Signaling Server brackets
(two of each)" (page 229) ) with the flange (B in Figure 76 "Signaling
Server support bracket" (page 230) ) toward the back of the Signaling
Server. See Figure 76 "Signaling Server support bracket" (page
230) .
Figure 76
Signaling Server support bracket
3 Align the screw holes in the rack-mount rail with the mating holes in
the side of the Signaling Server. Use three screws (C) on each side.
Hand-tighten the screws to prevent cross-threading then use a
Phillips screwdriver to secure them.
4 Attach the bezel door to the faceplate of the Signaling Server, as
shown in
Figure 77 "Left hinge mount" (page 231) and Figure 78
"Right hinge mount" (page 231) .
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.