Clid verification (clidver), Networked m911 – Nortel Networks NN43001-314 User Manual
Page 328
328
Emergency Services configuration
CLID verification (CLIDVER)
Use the CLIDVER prompt in LD 20 to verify that the ESA or non-ESA (SPN)
emergency number is properly composed and configured. Refer to
for more information.
Networked M911
The Networked M911 feature introduces a new trunk subtype 911P
exclusively for 911 calls redirected over an MCDN Network. A new prompt,
911P, is introduced in the Route Data Block for TIE trunks only. This prompt,
if set to YES, signifies that the trunks associated with these routes are 911P
trunks. All incoming 911 calls to the tandem M1 are redirected to the target
M1 over 911P trunks. At the target node, these calls will be treated in
respect the same as incoming calls on 911E/ 911T trunks.
A new trunk subtype is introduced in the Route Data Block exclusively for
TIE trunks. All the prompts specific to 911 are prompted in the RDB if the
TKTP prompt value is TIE. In case of TIE trunks, the M911_TRK_TYPE
prompt does not appear and is replaced by the newly introduced prompt
911P. The M911_ANI, M911_NPID_FORM and NPID_TBL_NUM are not
prompted in the RDB. If the 911P prompt is set to YES, IFC prompt is set to
SL1 by default since 911P trunks are supported only over MCDN.
Figure 117
New and changed prompts and responses in LD 16
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2007, Nortel Networks
.