Nortel Networks NN43001-314 - Manual (Page 239)

239
MG 1000B software installation
Contents
This section contains information on the following topics:
"Signaling Server software installation" (page 239)
"Materials required" (page 240)
"Creating the Signaling Server CD" (page 240)
"Installing the Signaling Server software" (page 241)
"Signaling Server tools" (page 241)
"Signaling Server port speed" (page 243)
"Verifying a successful configuration" (page 244)
"Connecting the MG 1000B Core to the network" (page 244)
"Connecting the MG 1000B Core to the network" (page 244)
"Using Element Manager to configure the node" (page 247)
"Installing MG 1000B Hardware" (page 249)
"Installing the cards" (page 250)
"Installing a DSP Daughterboard" (page 250)
"Installing the MGC card" (page 251)
"Installing the CP PM card" (page 252)
Signaling Server software installation
Software for the Signaling Server is installed using the Install Tool, which
runs from the Signaling Server Software CD-ROM. The Install Tool program
also upgrades existing Signaling Server software to the latest version. The
Signaling Server is out-of-service during software installation or upgrade.
To perform a software installation or upgrade, reboot the Signaling Server
with the Software CD-ROM in its drive. No floppy disk is required, since
the software CD-ROM is bootable.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.