Nortel Networks NN43001-314 - Manual (Page 246)

246 MG 1000B software installation
Procedure 21
Configuring the ELAN network interface IP address
Step Action
To configure the active ELNK Ethernet interface for the Branch Office:
1 Go into LD 117.
2 Create host entries with IP address on the ELAN subnet. Enter the
following command:
NEW HOST <hostname> <IP_addr>
3 Configure the ELAN network interface subnet mask. Enter the
following command:
CHG MASK <maskvalue>
where
<maskvalue> = nnn.nnn.nnn.nnn
4 Configure a new Routing Entry. Enter the following command:
NEW ROUTE <destination IP> <gateway IP>
where
<destination IP> is the ELAN network interface IP address
of the Media Card on the MG 1000B Core
<gateway IP> is the ELAN network interface IP address of the
MG 1000B Core
5 Verify the IP address for the Ethernet link. Enter the following
command:
PRT ELNK
6 Activate New Host entry. Enter the following command:
CHG ELNK ACTIVE <hostname>
7 Save the ELAN network interface configuration. Enter the following
command:
UPDATE DBS
8 For the changes to take affect, enter the following commands in LD
137 to disable and enable the ELNK:
DIS ELNK
ENL ELNK
—End—
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.