Nortel Networks NN43001-314 - Manual (Page 266)

266 MG 1000B telephones
Step Action
1 Connect the IP Phone to an Ethernet jack and configure the S1 IP
address (or use Dynamic Host Control Protocol (DHCP) to retrieve
the IP address).
The S1 IP address is the IP address of the MG 1000B TPS. If it is
entered as the main office TPS, the IP Phones register to the main
office, but do not behave as MG 1000B IP Phones.
2 Provision the basic Terminal Number (TN), Directory Number
(DN), and node data through the Set-Based Installation procedure
(
Procedure 24 "Using Set-Based Installation" (page 267) ). This
makes the set operational and provides basic provisioning for
survivability. Nortel recommends that the DN be the same at both
the main office and the Branch Office.
3 Configure the Branch User ID (BUID) and its Main Office TN (MOTN)
through
Procedure 25 "Configuring a Branch User" (page 271) .
—End—
These three steps are easily performed and enable an administrator to
install and provision a telephone.
WARNING
After all IP Phones have been installed, perform a datadump
(using LD 43 EDD or NRS Manager) on the MG 1000B Call
Server. Refer to Communication Server 1000E: Installation and
Configuration NTP (NN43041-310).
If you have already unpacked and connected the IP Phone, complete
Procedure 24 "Using Set-Based Installation" (page 267) . It simplifies
configuration of MG 1000B IP Phones for survivability. Each MG 1000B IP
Phone must also be provisioned at the main office.
To use DHCP addressing (using the automatic installation procedure,
see theCommunication Server 1000E: Installation and Configuration
NTP (NN43041-310) for more detail), verify that the network has DHCP
enabled. Refer to Converging the Data Network with VoIP Fundamentals
(NN43001-260) for more information.
The IP Phone screen display differs according to the telephone model in
use. For example, the screen displays shown in the procedures in this
section are for an IP Phone 2004. The IP Phone 2001 and IP Phone
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.