Nortel Networks NN43001-314 - Manual (Page 270)

270 MG 1000B telephones
Branch User Config
To complete the interface-based configuration of the Branch User, the
administrator or a trusted user can configure the IP Phone with the Branch
User Config command. Before proceeding, be sure to obtain the required
passwords as described in
"Password requirements" (page 265) .
If the Branch User ID (BUID) is not configured, the IP Phone registers at the
MG 1000B CP PM and stays in Local Mode. If the IP Phone is configured
with a BUID, it is automatically redirected to the main office TPS and then to
the main office Call Server. If there is a BUID, the MOTN is equal to the set
TN by default. If there is no BUID MOTN, it has not yet been configured. A
BUID is used for redirection, while the MOTN is used on the main office for
registration. Redirection may not be successful (refer to
Table 26 "Normal
Operation troubleshooting" (page 349) ).
Branch User Config is the IP Phone-based mechanism to enter the BUID
so that the IP Phone can be redirected to the main office to run in Normal
Mode. Branch User Config is an option on the Options menu display that is
available to the Branch User.
The menu option for Branch User Config is shown in Figure 100 "Options
menu" (page 270) .
Figure 100
Options menu
If an SCPW has been configured, "Password Admin" appears in the list as
the second option, forcing the "Branch User Config" option to scroll out of
sight. Use the navigation keys to scroll down to "Branch User Config".
To register an IP Phone to the main office, Branch User Config uses the
following:
• Branch User ID (BUID)
• Branch password — IP Phone Installer’s Password or Temporary IP
Phone Installer’s Password
• Main Office TN (MOTN), in either Large System format (four fields) or
Small System format (two fields). This defaults to the TN at the MG
1000B.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.