Nortel Networks NN43001-314 - Manual (Page 229)

Installing a Signaling Server 229
3. The power cable for the Signaling Server. Check that the power cord
is the exact type required in the host region. Do not modify or use the
supplied AC power cord if it is not the correct type.
4. The serial cable for the Signaling Server.
5. The CAT5 cables for networking.
6. The contents of the accessories pouch to install the Signaling Server.
The accessories pouch should contain the following items:
a. Two support brackets (A)
b. Two rack-mounting brackets (B)
c. Six rack-mount bracket screws (10-25 x 1/4" panhead Phillips)
d. Two bezel door long rack-mount screws
Refer to Figure 75 "Signaling Server brackets (two of each)" (page 229) .
If any parts are missing, contact your supplier immediately.
Figure 75
Signaling Server brackets (two of each)
CAUTION
The load rating for this mounting kit is 50 lb (23 kg). If you exceed
this limit, damage or injury can occur.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Copyright © 2007, Nortel Networks
.