Ricoh Aficio 2018D - Manual (Page 708)

Appendix
86
9
❖ ❖ ❖ ❖ Display
Shows SNMP information and
available protocols.
msh> snmp ?
The following command displays
the settings of registered number
specified.
msh> snmp [registered_number]
Omitting the number displays all
access settings.
msh> snmp [-p]
Note
❒ Add “-p” (as above) to have the
in formation d is played one
screen at a time.
❖ ❖ ❖ ❖ Community name configuration
You can set the community name
of the registered number.
m s h > s n m p n u m b e r n a m e
community_name
Note
❒ The community name can con-
sist of up to 15 characters.
❖ ❖ ❖ ❖ Access type configuration
You can select the access type from
those listed below:
m s h > s n m p n u m b e r t y p e
access_type
❖ ❖ ❖ ❖ Protocol configuration
You should use the following com-
mand to set protocols to active or
inactive. If you set a protocol to in-
active, all access settings for that
protocol will be disabled:
msh> snmp {ip | ipx} {on |
off}
• “on” means active, “off” means
inactive.
To change an access setting proto-
col, use the following command.
However, if you have disabled a
protocol using the above com-
mand, making it active here will
have no effect.
msh> snmp number active
{ip | ipx} {on | off}
❖ ❖ ❖ ❖ Access configuration
You can configure a host address
according to protocols used.
The network interface board ac-
cepts requests only from hosts
with “read-only” or “read-write”
access type addresses. Enter “0” to
have the network interface board
accept requests from any host
without requiring a specific type of
access.
msh> snmp number {ip | ipx}
address
Note
❒ To specify TCP/IP protocol, en-
ter “ip” followed by a space,
and then the IP address.
❒ To specify the IPX/SPX proto-
col, enter “ipx” followed by a
space, and then the IPX address
followed by a decimal, and then
the MAC address of the net-
work interface board.
Access
type Type of access permitted
read Read only
write Read and write
trap User notified of trap mes-
sages.
no All access denied.