Hp-ux – Ricoh Aficio 2018D User Manual

Page 794

Advertising
background image

UNIX Configuration

12

1

B

Register the printer as a remote printer.

# lpadmin -p np -s nphost!option -T dump -I any

• “np” is the printer name. “nphost” is the host name. For more informa-

tion about “option”, see p.19 “Specifying the Device Option”.
“lp” will be assigned if the option is not used.
When printing with the “lp” command, use “_” instead of “=” and “;”
instead of “,” for operating systems that cannot use “=” and “,” such as
Solaris 2.5 or later.

C

If your workstation is Solaris 2.5.1, set the print job to active so it can be put
in the print queue.

/usr/lib/accept np

D

If your workstation is Solaris 2.5.1, set the print job to active to print.

/usr/lib/enable np

HP-UX

Adding the IP address and host name to the /etc/hosts file

The following line is added to the /etc/hosts file. The IP address and printer
host name previously entered in the installation script will be used:
192.168.15.16 np # Network Printer

• “192.168.15.16” is the IP address. “np” is the host name. The comment

comes after the #.

Note

❒ The /etc/hosts file contains a list of IP addresses and names of all hosts

communicating on the network. Each entry is delimited with a space or a
tab, and each line is separated with a return.

❒ If you do not use NIS or DNS, you must enter the IP address and host name

of each workstation using the network printer in the /etc/hosts file.

Registering the printer

The installation shell script registers the printer as a remote printer using the
procedure below:

A

Stop the scheduler.

/usr/lib/lpshut

B

Register the printer.

/usr/lib/lpadmin -Pnp -v/dev/null -mrmodel

-ormnphost -orpoption -ob3

• “np” is the printer name. “nphost” is the host name.

For more information about “option”, see p.19 “Specifying the Device
Option”
.
“lp” will be assigned if the option is not used.

Advertising
This manual is related to the following products: