Ricoh Aficio 2018D - Manual (Page 714)

Appendix
92
9
Note
❒ Enter the printer name using up to
15 characters.
❒ You cannot use a printer name
starting with “RNP” or “rnp”.
❒ The Ethernet interface and IEEE
802.11b interface will have the
same printer name.
WINS
Use the “wins” command to config-
ure WINS server settings.
❖ ❖ ❖ ❖ Viewing setting
The following command displays
the WINS server IP address:
msh> wins
Example output:
msh> wins
WINS Configuration:
interface_name:
WINS: On
p r i m a r y s e r v e r 0 . 0 . 0 . 0
secondary server 0.0.0.0
ScopeID
Current configuration:
p r i m a r y s e r v e r 0 . 0 . 0 . 0
secondary server 0.0.0.0
hostname host_name Sco-
peID
Note
❒ If the IP address obtained from
DHCP differs from the WINS IP
address, the DHCP address is
the valid address.
❖ ❖ ❖ ❖ Configuration
Use the “set” command to make
WINS active or inactive.
msh> wins interface_name
{on | off}
• “on” means active; “off” means
inactive.
❖ ❖ ❖ ❖ Setting WINS Server Address
You can make settings for the
WINS server address.
msh> wins interface_name
{ p r i m a r y | s e c o n d a r y }
IP_address
• “primary” is for setting the pri-
mary WINS server address.
• “secondary” is for setting the
secondary WINS server ad-
dress.
❖ ❖ ❖ ❖ NBT scope ID setting
You can configure the NBT scope
ID.
Limitation
❒ Enter a scope ID using up to 31
alphanumeric characters.
msh> wins interface_name
scope scope_ID
Note
❒ If you receive different scope
IDs from DHCP and WINS, the
scope ID from DHCP takes pri-
ority.
*1 Available when the optional
802.11b interface unit is installed.
*2 Available when the optional 1394
interface board is installed.
Interface
name Interface to be config-
ured
ether Ethernet interface
wlan *1 IEEE 802.11b interface
ip1394 *2 IEEE 1394 interface