Omron Programmable Terminals NT631C - Manual (Page 175)

158
Setting Conditions for Communications with Host by Using Memory Switches Section 6-7
6-7-4 Setting the NT Link (1:N) Method (Standard/High-speed)
Set the communications conditions for the NT Link (1:N) method at serial port
A or serial port B by following the operation from the System Menu shown
below.
The communications speed determines whether the 1:N NT Link is standard
or high-speed.
Standard: Standard 1:N NT Link
High-speed: High-speed 1:N NT Link
Select Maintenance Mode.
Select Memory Switch.
In this example, serial port A is used.
Ver 4.12
Display the fourth memory switch
screen by pressing the [
↓] (next screen)
or [
↑] (previous screen) touch switch.
Press the touch switch corresponding to the
port at which the NT Link (1:N) method
(standard or high-speed) is to be set
(Comm. A Method or Comm. B Method) to
display the setting option NT Link (1:N).
The setting option changes each time the
touch switch is pressed.