Omron Programmable Terminals NT631C - Manual (Page 232)

215
Programming Console Function Section 6-12
6-12-1 Usable Systems
The Programming Console function can be used with an NT631/NT631C con-
nected to a PLC when using the communications method indicated below.
*1
The peripheral port Programming Console always has priority. If a Pro-
gramming Console is connected later, the Programming Console function
of the NT631/NT631C is invalidated and operation from the NT631/
NT631C becomes impossible.
*2
The CPM2C-CN111 Connecting Cable splits the PLC’s Communications
Port into a RS-232C port and a peripheral port.
*3
An RS-232C cable cannot be connected to the peripheral port. An RS-
232C adapter (CPM1-CIF01) is required.
*4
The RS-232C cable cannot be directly connected to the peripheral port. An
RS-232C converting cable (CS1W-CN118) is required.
Reference: Note that the Programming Console function cannot be used with CPM1,
CQM1, and C200HX/HG/HE(-Z)E PLCs of the following lot numbers.
CPM1: @@@5, @@*6
where * is a number in the range 1 to 9 or the letter X or Y.
Communica-
tions Method
Applicable PLCs Connected Port
NT Link (1:1)
C200HE-CPU42-(Z)E
(*1)
C200HG-CPU43/63-(Z)E
(*1)
C200HX-CPU44/64-(Z)E
(*1)
C200HX-CPU65-ZE
(*1)
C200HX-CPU85-ZE (*1)
CPM2A-30CD @@-@
(*1)
CPM2A-40CD @@-@ (*1)
CPM2A-60CD @@-@ (*1)
CPM2C-10 @@@@@@-@
(*2)
CPM2C-20 @@@@@@-@
(*2)
CQM1-CPU4 @-EV1 (*1)
CQM1H-CPU21/51/61
(*1)
SRM1-C02-V2
CPU Unit’s built-in
RS-232C port
CPM1-10CDR- @
CPM1-20CDR- @
CPM1A-10CD @-@
CPM1A-20CD @-@
CPM1A-30CD @-@
CPM1A-40CD @-@
Peripheral port (*3)
NT Link (1:N) CS1G-CPU42/43/44/45-EV1
CS1H-CPU63/64/65/66/67-EV1
CS1G-CPU42H/43H/44H/45H
CS1H-CPU63H/64H/65H/66H/67H
CS1D-CPU66H/67H
CJ1G-CPU44/45
CJ1G-CPU42H/43H/44H/45H
CJ1H-CPU65H/66H/67H
CJ1M-CPU11/12/13/21/22/23
CPU Unit’s built-in
RS-232C port
Peripheral port
(*4)