11 system maintenance, 11-1 i/o settings, I/o settings – Omron Programmable Terminals NT631C User Manual

Page 204

Advertising

187

System Maintenance

Section 6-11

6-11 System Maintenance

The NT631/NT631C has the following maintenance and check functions.

This section describes how to use these functions.

6-11-1 I/O Settings

This function is used to adjust the contrast of the display panel and the bright-
ness of the backlight.

With the NT631/631C, you can adjust the contrast and brightness settings
using either of the following two methods.

Setting from the System Menu

Adjusting the contrast: Select System Menu/Maintenance Mode/I/O Settings/
Contrast Adjust.

Adjusting the brightness: Select System Menu/Maintenance Mode/I/O Set-
tings/Brightness Adjust.

Setting Using Special Screen During PT Operation

You can set the brightness and contrast by displaying the screen with the fol-
lowing number, using a touch switch with a switch screen function, or by spec-
ifying the display screen in the PT status control area.
Screen number 9030: Brightness and contrast adjustment screen.

Contrast Adjustment (for
NT631C-ST141

@-EV1

only)

The NT631C-ST141

@-EV1 allows the contrast to be adjusted in 100 steps.

The CONTRAST ADJUST screen enables you to make the adjustment while
actually checking the contrast on the screen. Once the contrast has been set,
it remains in effect even if the power is turned OFF or the NT631/NT631C is
reset (and even if the voltage of the built-in battery becomes low).

Item

Function

Page

I/O Settings

Adjustment of display panel contrast and brightness of the backlight.

187

Calendar Check

Display and setting of the time data of the NT631/NT631C clock function.

191

PT Settings

Direct connection setting of the screen data in the NT631/NT631C and display of the
setting statuses of the serial ports.

193