Omron Programmable Terminals NT631C - Manual (Page 231)

214
Programming Console Function Section 6-12
• If data does not reach the printer within 60 seconds after sending starts,
the message ‘Finished Printer output failed’ is displayed.
After confirming the result of the check, press Quit. The NT631/NT631C
returns to the I/F CHECK MENU screen.
6-12 Programming Console Function
The NT631/NT631C has been equipped with the Programming Console func-
tion, which allows it to be used like a C200H-PRO27-E Programming Console
for CPM1, CPM2A, CPM2C, CQM1, CQM1H, C200HX/HG/HE(-Z)E, CS/CJ-
series PLC, or SRM1 PLCs.
Except for recording (saving) ladder programs on cassette tape and replaying
(reading) them, almost all the functions of a Programming Console can be
executed.
Note When the programmable controller functions are used, carefully check that
the system is safe before carrying out the following operations.
• Changing monitor data
• Switching the operating mode
• Forced set or reset
• Changing a present value or set value