USRobotics NETServer/8 - Manual (Page 133)

Packet Filters 8-19
Editing Packet Filters
Edit a Packet Filter
See Filter Rule Format, earlier in the chapter for a description of
filter rule format. For information on filter rule options, see the
section specific to the type of packet filter you are editing.
To edit a filter, replace an existing rule with a new one. Use one
of the following commands:
set filter <name> <rule #> < permit | deny> <new options>
set ipxfilter <name> <rule #> < permit | deny> <new options>
set sapfilter <name> <rule #> < permit | deny> <new options>
When you are finished, save the filter with the following com-
mand:
save filters
Delete a Packet Filter Rule
To delete a rule, use the following command:
set filter <filter name> <rule #>
set ipxfilter <filter name> <rule #>
set sapfilter <fitter name> <rule #>
To delete all rules of a certain type, use the following command:
set < filter | ipxfilter | sapfilter> <filter name> blank
Delete a Packet Filter
To delete a specific packet filter, use the following command:
delete filter <filter name>
Save a Filter
Save your changes by issuing the following command:
save filters