USRobotics NETServer/8 - Manual (Page 282)

8 Index
SHOW command 3-5, 9-11
ARP 9-12
Filter 8-20
Flash 9-12
Global configuration 10-2
Help 3-5
Hosts 10-13
Init 7-7
Locations 10-15
Memory 9-13
Net0 10-25
Netconns 9-13
Netmasks 10-30
Netstat 9-14
Ports 10-34
Routes 10-50
SAP 6-29, 9-15
Sessions 9-15
SNMP 10-55
User 10-58
SLIP
Active interfaces 9-6
Authentication 6-30
Compression (CSLIP) 5-10, 6-17, 6-24,
10-18
Location configuration 6-15, 6-16, 6-17,
10-18, 10-21
MTU 5-9, 6-16, 6-23, 10-21, 10-45,
10-64
Overview 1-6
Port configuration 3-9, 10-35, 10-37,
10-45, 10-46
User configuration 3-2, 5-1, 5-9, 5-10,
6-23, 6-24, 10-57, 10-64
SNMP
Enable/disable 10-54
Help 10-54
Overview 3-10
Read/write community names 10-55
Read/write hosts 10-54, 10-56
Saving the SNMP table 10-54
System name 10-7
Viewing SNMP configuration 10-55
Specifications, technical. Appendix A
Static routes
Adding 10-49
Changing 10-49
Definition of 6-6
Deleting 10-50
Destination address 10-52, 10-53
Gateway 10-52
Help 10-49
Metric 10-52, 10-53
RADIUS user F-6
Saving 10-50
Ticks 10-53
Viewing 10-50
Statistics, viewing 9-14
Stop bits 10-47
Subnet mask
Definition of B-2
Hardwired port 10-45
LAN port 2-7, 10-27
Location 5-12, 6-16, 6-27, 10-17
Network dial in user 5-9, 5-12, 6-23,
6-26, 10-63
RADIUS user F-6
Supernetting B-5, 3-7, 10-30
Syslog network accounting 10-11, 10-12,
Appendix D
Sysname (system name) 2-4, 6-2, 6-10,
6-22, 6-26, 6-27, 6-30, 10-7
System administrator requirements 2-2
T
TCP packet filters 8-10
TCP port number
Command line interface 9-2
Filtering packets by 8-10
Login service F-7, 4-6, 4-10, 4-14, 10-42
Modem 3-9, 7-1, 7-4
TCP/IP. See TCP and IP
Technical specifications. Appendix A
Technical Support vii
Telnet
Administrative session 9-1, 9-2
Bandwidth requirements 6-18, 10-20
Device service 7-1, 7-3, 10-36
Filtering 8-11, 9-9
Login port service 4-6, 4-14, 10-42
Login user service F-7, 4-10, 4-15, 10-60
Network dial in user 5-14
Overview 3-2, 3-11, 4-2, 10-35
Telnet access port 9-2
TELNET command 6-29, 9-3
Terminal server, using NETServer as.
Chapter 4
Example 4-12–4-15
Overview 1-5
Port configuration 4-4–4-8
Terminal setup 4-1
User setup 4-9–4-11
Terminal type 4-7, 4-13, 4-15, 10-43
Ticks, IPX route 10-53
Total Control Manager F-1
Troubleshooting commands 9-4–9-10