USRobotics NETServer/8 - Manual (Page 241)

Software Download C-3
PCSDL commands can be in either upper or lower case letters.
Leave one space after each command line parameter. The d
command is optional, the rest are required.
Note: After the Install utility copies files to your hard disk, it is
important not to change the file names or try to edit the files.
This will cause an error message to be displayed when you run
the SDL program. You will also need to know these file names
to launch SDL.
The table below shows what the file name means:
Filename Prefix Version # File Type
pn030100.nac pn 3.1.0 NAC
(NETServer/8) (03 01 00)
tr010200.sdl tr 1.2.0 SDL
(NETServer/8) (01 02 00)
SDL Command Syntax
The following is a sample of the command syntax based on the
sample file names above. The table that follows explains each
parameter.
pcsdl -p1 -r57600 -vsd1.2.0 -vna3.1.0 -nsdtr
-nnapn
Parameter Purpose
pcsdl initiates the PC SDL program
-p selects communication port on the PC cabled to
the NETServer (required); possible ports are 1, 2,
3, or 4.
-r57600 selects serial port transmission rate of 57600 bps
-vsd software download file version number (re-
quired)
-vna software .nac operation code version number
(required)
-nsd specifies the .sdl filename prefix (required):
(tr = NETServer/8 and NETServer/16 SDL file)