USRobotics NETServer/8 - Manual (Page 148)

9-14 Administrative Tools
Foreign Address The address of the port on the remote side of a
point-to-point connection. IPX port addresses
appear as 00000000.0.
(State) The status of the connection. Possible values
include SPX LISTEN, UDP, and LISTEN.
show netstat
The show netstat command provides information on network
statistics, specifically on each network interface or ptp (point-to-
point) connection.
show netstat
The information you see might look something like this:
Name Ipkts Ierrs Opkts Oerrs Collis Resets Queue
net0 40 0 7 0 0 0 0
Name Name of the interface, for example, ptp12 (point to
point connection on port s12).
Ipkts How many packets the interface has received.
Ierrs How many damaged packets the interface received.
Opkts How many packets were sent by the interface.
Oerrs How many of the packets sent by the interface
caused an error condition.
Collis How many collisions were detected by this interface.
Resets How many times the interface has been reset.
Queue How many packets are in the queue, waiting to be
sent. This field should normally be zero.
The following command resets these counters to 0:
reset netstat