USRobotics NETServer/8 User Manual
Page 15
Overview 1-7
Dial-Up Routing
The same routing engine that allows network dial in access
allows the NETServer to establish dial up routing sessions with
remote networks. Such connections can be maintained
continuously or established on an on-demand basis and torn
down when not needed.
How do I get there from here?
Configuring any of these applications on a NETServer is a three-
step process:
Perform basic configuration for the NETServer. This
includes configuring it to talk to your LAN and setting
global user and global routing parameters. You can begin
this process by going to Chapter 2.
2.
Configure modem “S-ports” to support the application
Configure user table entries for dial in connections and IP
modem sharing, location table entries for dial out routing.
Steps 2 and 3 are covered by application in chapters 4 through 7.
1.
3.