View the ports table – USRobotics NETServer/8 User Manual
Page 182
10-32 Command Reference
When a NETServer reboots, it copies configuration data from
the permanent configuration saved in flash memory to the
default configuration work area. The port is then reset, which
makes that configuration active. You can change the permanent
configuration by issuing one of the following commands, which
copy the default configuration to flash memory:
save s<port #>
save all
View the Ports Table
To view all of the S-ports, use the following command:
show all
Local Addr:192.77.206.57
Default Host: 0.0.0.0
Gateway: 0.0.0.0
Netmask: 255.255.255.0
Port Speed
Mdm Host
Type
Status
Input Output Pend
—— ———
—— ———————
———
——————
——— ——— ——
S0
9600
off
Login/
COMMAND
1362
17663
2
S1
115200
on
192.77.203.5
Login/
IDLE
0
0
0
S2
115200
on
192.77.203.6
Login/
ESTABLISHED
1246
15842
0
S3
115200
on
192.77.204.26
Network/ ESTABLISHED
1757
43367
1
S4
115200
on
Network/ IDLE
0
0
0
S5
115200
on
192.77.203.5
Login/
IDLE
0
0
0
S6
115200
on
192.77.203.5
Login/
IDLE
0
0
0
S7
115200
on
192.77.203.5
Login/
IDLE
0
0
0
S8
115200
on
192.77.203.5
Login/
IDLE
0
0
0
Port
The number of each S-port.
Speed
This displays the baud rate that the port is configured
for.
Mdm
This field indicates whether Modem Control has been
enabled or not. See page 10-44 for more information
on Modem Control.