USRobotics NETServer/8 - Manual (Page 199)

Command Reference 10-49
Routes Table Configuration
The routes table contains both static and dynamic routing
information. Dynamic routes are updated by RIP broadcasts
received from other routing devices on the network. Static
routes are routes added to the table by hand. A static route to a
given location will override any dynamic routes to the same
location. Static routes are required when dynamic routes to a
given location are not being received (For example, when RIP is
not running).
How to . . .
Bring Up the List of Commands
Use the following command for the IP Routes table:
help set route
Use the following command for the IPX Routes table:
help set ipxroute
Add a Route to the Routes Table
To add IP route, use the following command:
add route <destination> <gateway> <metric>
To add an IPX route, use the following command:
add ipxroute <destination> <gateway> <metric> <ticks>
Change a Route’s Information
To change a route’s entry in the Routes Table, you must delete
the old route and replace it with a new one.