USRobotics NETServer/8 - Manual (Page 87)

LAN-to-LAN Routing 6-13
Step 2 - Creating a Dial-Out Group
Dialout and Twoway ports only. If the NETServer will dial out
to a remote location, you must create a group of modems that
can be used to dial out to the location. Note that you must do
this even if only one modem will be used for that particular
location. The following command creates such a group:
set s<port #> group <group #>
<group #> is any number from 0 to 99. The example below
creates group #2, which consists of ports 5 and 6:
set s5 group 2
set s6 group 2
Step 3 - Save your work
Save the changes to flash memory. Use the following command:
save s<port #>
Reset the port so the changes take effect by using the following
command:
reset s<port #>