USRobotics NETServer/8 - Manual (Page 214)

10-64 Command Reference
Routing
Default is off. This determines whether the NETServer ex-
changes routing information (RIP messages) with the dial in
user. Use the following command:
set user <user name> routing < on | broadcast | listen | off>
On The NETServer sends RIP information to the dial in
user and listens for dynamic routes received from
the dial in user.
Broadcast The NETServer sends RIP information to the dial in
user, but does not listen for dynamic routes received
from the user.
Listen The NETServer listens for dynamic routes received
from the dial in user, but does not send any.
Off The NETServer does not exchange routing informa-
tion with this user.
MTU
This is the Maximum Transmission Unit (MTU) used with this
interface. Use the following command:
set user <user name> mtu <value>
IPX connections require an MTU of 1500.
PPP connections are set between 100 and 1500 (default 1500).
SLIP connections are set between 100 and 1006 (default 1006).
Compression
This enables (on) or disables (off) Van Jacobson TCP/IP header
compression. Use the following command:
set user <user name> compression < on | off>
Input Filter
Optional. This is a packet filter that screens all packets received
from the user. See Chapter 8 for more information on packet
filters. Use the following command:
set user <filter name> ifilter <filter name>