USRobotics NETServer/8 - Manual (Page 61)

Network Dial In Access 5-3
Configuration
A. Configure at least one port for a network dial in connection.
See Configuring a Port, later in this chapter, for details.
B. Decide whether the dial in user is a normal user or a
dialback user. If the he or she is a dialback user, you must
create a Location Table entry for that user.
Note: Configuring the Location Table is not covered in this
chapter. For detailed information on the Location table see
Chapter 10. For a Location Table walkthrough, see Adding a
remote device to the Location Table in Chapter 6.
C. Create an entry in the User Table for each dial-in user. See
Adding a Remote User to the User Table, later in this chapter.