USRobotics NETServer/8 - Manual (Page 163)

Command Reference 10-13
Hosts Table
Like a name service, the hosts table translates names to IP
addresses and vice versa. However, the hosts table is only used
by the NETServer itself, rather than the entire network. If you
are not using a name service and you want to use names rather
than IP addresses, you must first create host table entries for all
the hosts you want to refer to.
How to . . .
Add a Host
To add a host to the Hosts Table, use the following command:
add host <IP address> <name>
Delete a Host
To delete a host, use the following command:
delete host <IP address or name>
Save Changes
To save changes you have made, use the following command:
save host
View the Hosts Table
To view the Hosts Table, use the following command:
show table host
The information you see might look something like this:
IP Address Host Name
————————— ———————
192.77.203.69 frank
201.55.23.77 delphi