USRobotics NETServer/8 - Manual (Page 54)

4-12 IP Terminal Server Setup
IP Terminal Server Case Studies
The following examples set up users to log into the two hosts in
the illustration below.
IP Terminal Server - Case Studies
Example 1
UserA, UserB, and UserC are all Login Users with entries in the
user table. An application on VAX1 is connected to a dial-up
information database that is open to the public (those not in the
user table).
Before you begin
Make sure the NETServer is properly configured.
•
the NETServer must have an IP address assigned to it
•
the NETServer’s netmask must match the one being used on
the local network.
See Minimum Configuration in Chapter 2 for instructions on how
to set these parameters.