USRobotics NETServer/8 - Manual (Page 175)

Command Reference 10-25
View LAN Port Configuration
Use the following command:
show net0
The information you see might look something like this:
Ethernet Status: IP - Enabled IPX - Enabled
Ethernet Address: 00:C0:49:00:45:43
Ethernet Media: Autodetect
Interface Addr: 192.77.203.55
Netmask 255.255.255.0
Broadcast Address: 192.77.203.255
IPX Network: 00000002
IPX Frame Type: Ethernet_II
Routing: Broadcast, Listen (on)
Input Filter:
Output Filter:
LAN Port Parameters
Ethernet Status
You can disable or enable the IP (or IPX) protocol on the net-
work interface. The default is IP enabled, IPX disabled. How-
ever, assigning an IPX network number to the Net0 interface
will enable IPX automatically. Note, disabling IP will also
disable the Windows-based management software. Use the
following commands to enable or disable the IP and IPX proto-
cols:
set net0 ip < up | down>
set net0 ipx < up | down>
up enables the protocol; down disables it.