USRobotics NETServer/8 - Manual (Page 180)

10-30 Command Reference
Netmask Table
The netmask table is used to define netmasks for Supernetting
(Classless InterDomain Routing). See Appendix B for an
explanation of this technique.
Alternatively, the netmasks table could be used to force the
NETServer to advertise routes to individual hosts on that
network rather than a single route to the entire network. To do
this, assign the desired network a netmask of 255.255.255.255.
How to...
Add a netmask
To add a netmask you need to enter both the IP network address
and the netmask using the following command:
add netmask <IP network> <netmask>
For example:
add netmask 192.77.203.0 255.255.255.255
Delete a netmask
Use the following command to delete netmasks:
delete netmask <IP network>
Save Changes
Use the following command to save changes to the netmask
table:
save table netmask
View the netmask table
Use the following command to view the netmask table:
show table netmask