USRobotics NETServer/8 - Manual (Page 156)

10-6 Command Reference
Default Route
This command determines whether the NETServer will dynami-
cally update IP default gateway information. The default is off.
Use the following command:
set default < on | broadcast | listen | off>
On The NETServer will broadcast its default gateway
information as part of normal RIP messaging and
will also listen for default gateways broadcast by
other routing devices.
Broadcast The NETServer will broadcast its default gateway
information as part of normal RIP messaging, but
will not listen for default gateways.
Listen The NETServer will listen for default gateway
information coming from other routers. However,
it will not broadcast such information.
Off The NETServer neither sends default gateway
information to other routers nor listens for default
gateways.
Note: The NETServer will use a default route broadcast by
another router only if Default Route is set to on or listen and the
metric of the route received is lower than the metric of the IP
Default Gateway. In such a case, the broadcast default route will
override the Default Gateway setting.
IP Address Spoofing
This command configures the IP address that the NETServer
reports to remote networks. This allows more than one
NETServer to appear to have a single IP address. The default is
0.0.0.0 (no IP address spoofing).
set reported_ip <IP address>