USRobotics NETServer/8 - Manual (Page 70)

5-12 Network Dial In Access
Create user table entries for the dial in users
Use the following commands to create User A:
add netuser userA password userApw
set user userA address 192.77.203.100
set user userA netmask 255.255.255.0
set user userA protocol ppp
set user userA mtu 1500
set user userA routing on
User B will be configured to use CSLIP (Compressed SLIP)
add netuser userB password userBpw
set user userB address 192.77.203.101
set user userB netmask 255.255.255.0
set user userB protocol slip
set user userB compression on
set user userB mtu 1006
set user userB routing on
Create a user table entry for the dialback user
Only two lines are required for the dialback user table entry.
The user table configures dial in connections. The NETServer
dials OUT to a dialback user. The first line looks like this:
add netuser userC password callmeback
Dial out connections are configured with the location table. The
second line of the user table entry specifies the location to use.
Before we can this line to the user table, we must create the
location to be used. Note that the location type is manual, since
we want the NETServer to dial the user only when it is specifi-
cally asked to do so.
add location sales_1
set location sales_1 manual
set location sales_1 destination 192.77.203.102
set location sales_1 netmask 255.255.255.0
set location sales_1 protocol ppp
set location sales_1 mtu 1500
set location sales_1 routing on
set location sales_1 script 1 “atdt5551000\r” ”CONNECT”
(To contact UserC, dial 555-1000 and wait for “CONNECT”)