USRobotics NETServer/8 - Manual (Page 93)

LAN-to-LAN Routing 6-19
Maximum Ports
Sets the maximum number of ports the NETServer can use for a
single connection to the remote location. Use the following
command:
set location <location name> maxports <0 .. 16>
0 (default) disable dialout to the location.
1 Use only one port for a connection. This setting must be
used if the remote device is not another NETServer.
2+ When the number of bytes queued for the remote location
exceeds the High Water Mark, another line will be added to
the connection if it is available.
Additional setup for multiple line connections
A NETServer on the answering end of a connection must receive
each incoming call on a different line even though the other
NETServer is dialing the same number every time (there is only
one dial script per location). There are two ways to accomplish
this:
The first is to have a single phone number on the receiving end
of the connection set up on a hunt group. A hunt group routes
calls through a single phone number out to the first available
line.