YSI IQ SensorNet 2020 XT Terminal - Manual (Page 57)

System 2020 XT USB Installation
3 - 27 ba76019e01 12/2012
3.5.5 Installing terminal components
The terminal component is the operating and control unit of the
IQ S
ENSOR N ET . It serves as an input and output device and is
necessary to operate the IQ S ENSOR N ET .
You can install the following terminal components:
 Terminal MIQ/TC 2020 XT
(compatible terminals, see section 1.4)
 MIQ/IF232 interface component with software terminal (see MIQ/
IF232 component operating manual)
The terminal component is installed on the lid of any free MIQ module.
The MIQ/TC 2020 XT configured as a terminal is docked on the lid of
any free MIQ module.
If the MIQ/TC 2020 XT is configured as a controller, the MIQ/
TC 2020 XT, as opposed to a mobile terminal (e.g. MIQ/TC 2020 XT
configured as terminal) must not be removed during operation. To
protect against any inadvertent removal, the MIQ/TC 2020 XT can be
secured with a locking screw.
Materials required - none -
Tools  Phillips screw driver.
Docking the terminal
component
Fig. 3-18 Preparing the MIQ module for docking
Note
For the temporary docking of a mobile terminal, do not remove the
1 Pull the cover off the contacts (pos. 1 in Fig. 3-18) on the lid of
the MIQ module.
1