Yokogawa digitalYEWFLO (DY-FF) - Manual (Page 146)

<APPENDIX 10. METHOD>
A10-1
IM 01F06F00-01EN
APPENDIX 10. METHOD
A10.1 Transducer Block
METHOD is a program to facilitate the parameter settings.
Set TR block to “O/S”, for parameter setting by METHOD.
(1) Setup Wizard Method
*1: Skip mode including
Do you want to set
the following parameter:
FLUID_TYPE
Set the following parameter:
FLUID_TYPE
END
Set the following parameter:
BASE_TEMP
Set the following parameters:
PRESSURE_UNIT
PROCESS_PRESSURE
BASE_PRESSURE *1
Set the following parameter:
DEVIATION *1
Liquid: Volume
Gas/Steam: Volume
Liquid: Mass
Gas/ Steam: Mass
Gas: STD/ Normal
Setup Wizard terminating
Yes
No
Cancel
(Abort)
*1
Sub-method
FLUID_TYPE
Setup Wizard Method
Display the start message
Check the Mode.Actual
(automatically judgement)
Set the following parameter:
TEMPERATURE_UNIT
PROCESS_TEMP
Check the
SENSOR_STATUS
(automatically judgement)
Jump to method of
FLUID_TYPE
Jump to method of
THERMOMETER_FUNCTION
Set the following parameters:
DENSITY_UNIT
PROCESS_DENSITY *1
Do you want to set the
following parameter:
CHARACTERIZE_METER
Set following parameter:
SIZE_SELECT
BODY_TYPE
VORTEX_SENSOR_TYPE
K_FACTOR_UNIT
K_FACTOR *1
Display the PV Range value
Display the end message
END
Standard
No
Built-in
Temp Sensor
Yes
OOS
Auto
*1: Skip mode including
*1
FA1001.ai