Parameter setting, 1. maintenance mode, 1-1. introduction – Yokogawa EXA ISC202 2-wire Conductivity Transmitter/Analyzer User Manual
Page 43: Parameter setting -1, 1. maintenance mode -1, 1-1. introduction -1
IM 12D06A03-01E
Parameter setting 5-1
ENT
NO
MODE
YES
MODE
MEASURE
CAL
DISPLAY
HOLD
5. PARAMETER SETTING
5-1. Maintenance mode
5-1-1. Introduction
Standard operation of the EXA transmitter involves use of the Maintenance (or operating) mode to set up
some of the parameters.
Access to the maintenance mode is available via the six keys that can be pressed through the flexible
window in the instrument front cover. Press the ‘MODE’ key once to enter this dialog mode.
(Note that at this stage the user will be prompted for a passcode where this has been previously set up
in service code 52, section 5-6)
Calibrate
: See ‘calibration’ section 6.
Display setting : See ‘operation’ section 5-1-3, 5-1-4
Hold
:
Manually switch on/off ‘hold’ (when enabled in commissioning menu see section 5-2-2)
Only if enabled in commissioning mode section 5-2
Press the MODE key
Only if enabled in commissioning mode section 5-2
mA