Daylight saving time setting, Other settings – Yokogawa Standalone MW100 User Manual
Page 138
3-16
IM MW100-01E
Daylight Saving Time Setting
1.
From the top screen, click
System Setting > Daylight Saving Time Setting.
2.
Select the
Daylight Saving Time check box. The Summer time and Winter time
function is enabled.
3.
Select a starting month, week, and day of the week for the start of Summer time
in the
Start Time box. Enter a start time in the box.
4.
Select an ending month, week, and day of the week for the end of Summer time
in the
End Time box. Enter an end time in the box.
5.
Click the
Apply button. The Summer time and Winter time start times are enabled.
Other Settings
This is for entering the MW100 unit number, units of temperature, alarm hold, rate-of-
change interval, and strain initial balance settings.
From the top screen, click
System Setting > Other Settings.
Unit Number
1.
Enter a number from 0 to 89 for identifying the MW100 unit in the
Unit No. box.
2.
Click the
Apply button. This enables the setting changes.
Temperature Unit
1.
Select Celsius
deg C or Fahrenheit deg F in the Temperature Unit list.
2.
Click the
Apply button. This enables the setting changes.
Alarm Status Hold
1.
If the
Hold check box is selected, alarms are held.
2.
Click the
Apply button. This enables the setting changes.
For a description of the alarm hold/non-hold, see “Alarms” in section 1.3.
Rate-of-Change Interval
1.
Enter the measurement count that determines the interval in the
Increase
Interval box under Rate-of-Change Alarm.
2.
Enter the measurement count that determines the interval in the
Decrease
Interval box under Rate-of-Change Alarm.
3.
Click the
Apply button. The settings for each item are applied.
For a description of the rate-of-change interval, see “Alarms” in section 1.3.
3.3 System Settings