Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 172)

148 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
show mpls config [lsp] /show running-config /show configuration
1
show mpls config [lsp] /show running-config /show configuration
The show mpls config command and show running-config command display specific MPLS
interface configuration information. The output of this command now contains additional
information indicating that the link protection is configured.
Syntax show mpls config
show running-config
show configuration
Parameters None.
Command
modes
This command runs in all modes.
Usage guidelines Use the show mpls config command or the show running-config command to display specific MPLS
interface configuration information.
Example Case 1: link protection requested
Brocade# show mpls conf
router mpls
……
lsp 1
to 10.44.44.44
adaptive
frr
link-protection
enable
Case 2: link protection not requested
Brocade# show mpls conf
router mpls
……
lsp 1
to 10.44.44.44
adaptive
frr
enable
History
Release Command history
Multi-Service NetIron Release 05.6.00 The output of this command now contains additional information
indicating that link protection is configured.
Multi-Service NetIron Release 05.5.00 This command was enhanced to display the label withdrawal delay setting.
Related
commands
None.