Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 447)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 423
53-1003031-02
Sample LDP configurations
2
Clearing the LDP packet statistics
The user can clear the LDP Packet Statistics, as shown in the following commands.
Brocade# clear mpls ldp statistics
Syntax: clear mpls ldp statistics
Sample LDP configurations
Figure 48 illustrates a sample configuration with three LDP-enabled LSRs.
FIGURE 48 Sample LDP configuration
Router R1
The following commands configure Router R1 in Figure 48 .
R1(config)# interface loopback 1
R1(config-lbif-1)# ip address 10.1.1.1/32
R1(config-lbif-1)# exit
Total The number of the errors of the Type described for the row, generated since the
Brocade device came up.
Since Last Clear The number of the errors of the Type described for the row, generated since the last
time a clear command was issued.
TABLE 64 Output from the show mpls ldp statistics command (Continued)
This field... Displays...