Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 828)

804 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Configuring 6PE
9
FIGURE 95 Deploying 6PE
CE1 configuration
This configuration example describes the operational requirements for the CE1 router. EBGP is
configured between the CE1 and 6PE1 routers, and the connected route is redistributed through
this connection.
CE1(config)# interface loopback 1
CE1(config-lbif-1)# ipv6 address 2001:db8:1111::1/128
CE1(config-lbif-1)# exit
CE1(config)# interface ethernet 1/1
CE1(config-if-e10000-1/1)# ipv6 address 2001:db8:1111::1/64
CE1(config-if-e10000-1/1)# exit
CE1(config)# router bgp
CE1(config-bgp)# local-as 2
CE1(config-bgp)# address-family ipv6 unicast
CE1(config-bgp-ipv6u)# neighbor 2001:db8:1111::2 remote-as 1
CE1(config-bgp-ipv6u)# redistribute connected
CE1(config-bgp-ipv6u)# exit
6PE1 configuration
This configuration example describes the operational requirements for the 6PE1 router. The 6PE
and the MPLS tunnel are configured between the 6PE1 and 6PE2 routers.
6PE1(config)# interface ethernet 1/1
6PE1(config-if-e10000-1/1)# ipv6 address 2001:db8:1111::2/64
6PE1(config-if-e10000-1/1)# exit
6PE1(config)# interface ethernet 1/2
6PE1(config-if-e10000-1/2)# ip address 10.30.30.1/24