Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 78)

54 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
bandwidth-ceiling
1
bandwidth-ceiling
This command adds a new threshold change point to the autobw-threshold table. If the change
point is already there, the value of the threshold is updated.
The [no] function of the command remove the bandwidth ceiling entry from the table.
Syntax [no] bandwidth-ceiling [bw in kbps|max] threshold threshold in kbps
Parameters bw in kbps
The bandwidth in kilobytes per second. 0 – 0x7FFFFFFF. Range of bandwidth in kbps.
threshold in kbps
The threshold in kilobytes per second. 0 – 0x7FFFFFFF. Range of bandwidth in kbps.
max
Sets the threshold for any traffic-rate above the maximum bandwidth-ceiling configured in the
table
Command
modes
This command operates in the MPLS global adjustment threshold configuration mode.
Usage guidelines Review the updated global adjustment-threshold table after this command is executed.
The first parameter indicates that any rate above the maximum ceiling configured.
The max keyword sets the threshold for any traffic-rate above the maximum bandwidth-ceiling
configured in the table.
History
Release Command history
Multi-Service NetIron Release 05.6.00 This command was introduced.
Related
commands
None.