Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 808)

784 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying VPLS auto-discovery information
8
Neighbor NLRI Negotiation The state of the NLRI negotiation with the neighbor. For example:
•
Peer negotiated IPv4 unicast capability
•
Peer negotiated L2VPN VPLS address family
•
Peer configured for IPv4 unicast routes
•
Peer configured for L2VPN VPLS address family
Neighbor AS4 Capability
Negotiation Whether this neighbor enabled 4 bytes ASN capability.
As-path attribute count The number of unique path attributes learned from this neighbor.
TCP Connection state The state of the connection with the neighbor. The connection can have one
of the following states:
•
LISTEN – Waiting for a connection request.
•
SYN-SENT – Waiting for a matching connection request after having
sent a connection request.
•
SYN-RECEIVED – Waiting for a confirming connection request
acknowledgment after having both received and sent a connection
request.
•
ESTABLISHED – Data can be sent and received over the connection.
This is the normal operational state of the connection.
•
FIN-WAIT-1 – Waiting for a connection termination request from the
remote TCP, or an acknowledgment of the connection termination
request previously sent.
•
FIN-WAIT-2 – Waiting for a connection termination request from the
remote TCP.
•
CLOSE-WAIT – Waiting for a connection termination request from the
local user.
•
CLOSING – Waiting for a connection termination request
acknowledgment from the remote TCP.
•
LAST-ACK – Waiting for an acknowledgment of the connection
termination request previously sent to the remote TCP (which includes
an acknowledgment of its connection termination request).
•
TIME-WAIT – Waiting for enough time to pass to be sure the remote TCP
received the acknowledgment of its connection termination request.
•
CLOSED – There is no connection state.
Maximum segment size The TCP maximum segment size.
TTL check The TCP TTL check.
Byte Sent The number of bytes sent.
Byte Received The number of bytes received.
Local host The IP address of the Brocade device.
Local port The TCP port the Brocade device is using for the BGP4 TCP session with the
neighbor.
Remote host The IP address of the neighbor.
Remote port The TCP port the neighbor is using for the BGP4 TCP session with the
Brocade device.
ISentSeq The initial send sequence number for the session.
SendNext The next sequence number to be sent.
TotUnAck The number of sequence numbers sent by the Brocade device that have not
been acknowledged by the neighbor.
TABLE 148 Output for the show ip bgp l2vpn vpls neighbors command (Continued)
This field... Displays...