Enabling vll mtu enforcement (optional), Specifying a lag group as the endpoint of a vll – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual

Page 564

Advertising
background image

540

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide

53-1003031-02

Configuring MPLS VLLs

4

Specifying a LAG group as the endpoint of a VLL

The endpoint of a VLL can be a LAG group. When the endpoint of a VLL is a LAG group, the VLL
traffic load is distributed to the customer edge (CE) device across all of the LAG group’s ports, using
a hashing mechanism.

Figure

59

illustrates a sample configuration where a LAG group of two ports serves as the endpoint

of a VLL.

FIGURE 59

Specifying a LAG group as the endpoint of a VLL

To configure a LAG group like the one in

Figure

59

, enter commands such as the following.

Brocade(config)# lag red dynamic

Brocade(config-lag-red)# ports ethernet 1/1 to 1/2

Brocade(config-lag-red)# primary port 1/1

Brocade(config-lag-red)# ports ethernet 1/2

Brocade(config-lag-red)# deploy

To configure a VLL like the one in

Figure

59

, enter commands such as the following.

Brocade(config)# router mpls

Brocade(config-mpls)# vll test2 40000

Brocade(config-mpls-vll)# vll-peer 10.10.10.10

Brocade(config-mpls-vll)# untagged e 1/1

NOTES:

When the user first creates a LAG and then configure a VLL instance, the port the user

specifies as the VLL endpoint must also be the port the user specified as the primary port of the LAG
group:

•

When the user later deletes the LAG from the configuration, only the primary port is
still a port of the VLL and all secondary ports become normal ports.

•

When the user specified a tagged endpoint for the VLL instance, all of the ports in the
LAG must be tagged.

•

Traffic received from any port in the LAG is forwarded to the VLL instance. All traffic is
matched to its VLAN.

•

Both static and dynamic LAGs are supported.

Enabling VLL MTU enforcement (optional)

The user can selectively enable local and remote VLL MTU mismatch checking using the following
command.

Brocade(config)# router mpls

Brocade(config-mpls)# vll-mtu-enforcement

Syntax: [no] vll-mtu-enforcement

Advertising