Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 770)

746 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Overview
7
ICMP Supported
ICMP Redirect Message Supported
ICMP Unreachable Message Not supported
OSPF Supported
IS-IS Supported
RIP Supported
BGP Supported
Trunk Ports (LAG) Supported
L2 Multicast Supported
IGMP Snooping Supported
L2 ACL Supported
L3 ACL Supported
Rate Limiting Supported
PBR Not supported
Multi-netting Supported
VRRP/VRRP-E Supported (Brocade MLX Series and NetIron XMR only)
IP Helper Address/ BootP/DHCP Supported
ECMP Supported
IP MTU Not supported. Note: IP MTU is ignored for L3 packets whose next hop is
over the VPLS local endpoint or VPLS remote endpoint no matter what
interface the packet arrived from.
VE over VPLS as MPLS interface Not supported. The VE configured on VPLS cannot be an MPLS interface.
Dual Tag Mode Not supported
L3 Multicast (PIM/DVMRP) Not supported
BFD Not supported
GRE Not supported
RPF Not supported on MPLS Uplinks on Brocade MlX series and NetIron XMR
series routers.
Not supported on the NetIron CES and NetIron CER devices.
IPv6 Not supported
PBB Not supported
MCT Not supported
IP Unnumbered Not supported
IRDP Not supported
Route-only Not supported
DHCP Supported
ACL -
ip acc redirect-deny-to-interf slot/port Supported on Brocade MlX series and NetIron XMR series routers.
Not supported on the NetIron CES and NetIron CER devices.
TABLE 139 Routing over VPLS supported features
Protocol Support