Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 184)

160 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Static transit LSP
1
router mpls
policy
traffic-engineering isis level-1
mpls-interface ethernet 2/14
lsp c2
to 14.14.14.14
traffic mean-rate 10
enable
static-lsp transit t1
in-label 100
out-label 101
next-hop 10.1.1.2
enable
Syntax: show mpls config
Show run
The show run command display includes the static-LSPs configuration in the MPLS section of the
configuration.
Brocade# show run
router mpls
policy
traffic-engineering isis level-1
mpls-interface ethernet 2/14
lsp c2
to 14.14.14.14
traffic mean-rate 10
enable
static-lsp transit t1
in-label 100
out-label 101
next-hop 10.1.1.2
enable
Syntax: show run
Syslog message display output
The following syslog messages will be displayed.
1. Static LSP goes UP:
MPLS: Static LSP st5 at transit is UP
2. Static-LSP goes down:
MPLS: Static LSP st6 at transit is DOWN
3. Static-LSP gets updated.
MPLS: Static LSP st6 at transit UPDATED