Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 797)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 773
53-1003031-02
Example configuration
8
Brocade(config)# router mpls
Brocade(config-mpls)# mpls-interface ethernet 1/1
Brocade(config-mpls)# vpls C1 10
Brocade(config-mpls-vpls-C1)# auto-discovery
Brocade(config-mpls)# exit
Brocade(config-mpls)# vpls C2 20
Brocade(config-mpls-vpls-C2)# auto-discovery
Brocade(config-mpls-vpls-C2)# exit
Brocade(config-mpls)# exit
Brocade(config)# router bgp
Brocade(config-bgp)# address-family l2vpn vpls
Brocade(config-bgp-l2vpn-vpls)# neighbor 10.1.1.1 activate
Brocade(config-bgp-l2vpn-vpls)# exit-address-family
Brocade(config-bgp)# exit
Brocade(config)#
After applying the above commands, the user can use various show commands to display
information about the VPLS auto-discovery configuration. In the show command examples that
follow, the lines in bold type indicate the information specific to the VPLS auto-discovery
configuration.
NOTE
The show mpls vpls name command has changed. The total VC labels allocated field is no longer
displayed in the output of the show mpls vpls name command.