Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 851)

TABLE 164 Output from the show mpls statistics 6pe vrf command
Field Description
In-Port(s) Shows the port for which the 6VPE traffic is received or sent.
Endpt Out-Pkt Shows the number of 6VPE packets received from the MPLS network and sent as IPv6 packets
to the IPv6 cloud.
Tnl Out-Pkt Shows the number of IPv6 packets received from the IPv6 cloud and sent as 6VPE packets to
the MPLS network.
NOTE: Due to hardware limitations, this statistic is not displayed when the command is run on
the Brocade NetIron CES or Brocade NetIron CER devices.
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 827
53-1003031-02
Displaying 6VPE information
9
Displaying the 6VPE packet count for a specified VRF
Run the show mpls statistics 6pe vrf vrf name command to display the 6VPE packet for a specified
VRF.
Brocade# show mpls statistics 6pe vrf Red
VRF Name In-Port(s) Endpt Out-Pkt Tnl Out-Pkt
Red e1/1 - e1/2 184116072 1697803327
e1/3 - e1/4 389547885 6036111
e2/1 - e2/24 1088610 0
e2/25 - e2/48 0 248406
Syntax: show mpls statistics 6pe vrf vrf name