Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 198)

174 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Dynamic Bypass LSPs
1
Globally enabling dynamic bypass
Using the dynamic-bypass command in MPLS router configuration mode for the first time enables
the dynamic bypass feature in the system. When using the dynamic-bypass command in the MPLS
router configuration mode which is already configured, there is no change in the existing status
(enabled or disabled) of global dynamic bypass. To enable the dynamic bypass on MPLS router
mode, enter a commands such as the following.
Brocade(config-mpls)# dynamic-bypass
Brocade(config-mpls-dynamic-bypass)# enable
Syntax: [no] dynamic-bypass
Syntax: [no] enable
The [no] form of the command disables the feature on the router.
Enabling all interfaces
Use the enable-all-interfaces command to enable dynamic bypass on all MPLS interfaces on a
router. This is applicable to all MPLS interfaces where the user has not configured dynamic bypass
manually. To set the optional global dynamic bypass configuration, enter a command such as the
following.
Brocade(config-mpls-dynamic-bypass)# enable-all-interfaces
Brocade(config-mpls-dynamic-bypass)#
Syntax: [no] enable-all-interfaces