Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 627)

mu1(config-mpls)# show ip route isis
Type Codes - B:BGP D:Connected I:ISIS O:OSPF R:RIP S:Static; Cost - Dist/Metric
ISIS Codes - L1:Level-1 L2:Level-2
OSPF Codes - i:Inter Area 1:External Type 1 2:External Type 2 s:Sham Link
Destination Gateway Port Cost Type Uptime
1 0.0.0.0/0 10.1.1.1 lsp tomu3 115/2 IL2 0m2s
2 10.2.1.0/24 10.1.1.1 lsp tomu3 115/11 IL2 0m2s
3 10.3.1.0/24 10.1.1.1 lsp tomu3 115/1 IL2 0m2s
4 10.4.1.1/32 10.1.1.1 lsp tomu3 115/1 IL2 0m2s
5 10.2.2.2/32 10.1.1.1 lsp tomu3 115/1 IL2 0m2s
6 10.1.0.0/16 DIRECT drop 115/10 IL1 3m54s
7 10.2.1.1/32 10.1.1.1 lsp tomu3 115/1 IL2 0m2s
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 603
53-1003031-02
IS-IS shortcuts
5
The following example shows an IS-IS shortcut configuration with route advertisements enabled.
Brocade(config-mpls)# lsp tomu3
Brocade(config-mpls-lsp-tomu3)# disable
Disconnecting signaled LSP tomu3
Brocade(config-mpls-lsp-tomu3)# shortcuts isis level2 announce
Brocade(config-mpls-lsp-tomu3)# enable
Connecting signaled LSP tomu3
In the output for this configuration, the bold text indicates that the device uses the extended TLV
fields to advertise the shortcut in an IS adjacency TLV. when route advertisements are not enabled,
this text would not appear in the output.