Bandwidth-ceiling max threshold – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 79
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
55
53-1003031-02
bandwidth-ceiling max threshold
1
bandwidth-ceiling max threshold
This command sets the threshold for any traffic-rate above the maximum bandwidth-ceiling
configured in the table.
The [no] function of the command removes the entry.
Syntax
[no] bandwidth-ceiling max threshold threshold in kbps
Parameters
max
Any rate above the maximum ceiling configured. By default, the last ceiling is used.
threshold in kbps
Threshold in kilobytes per second. 0 – 0x7FFFFFFF. Range of bandwidth in kbps.
NOTE
The first parameter indicates that any rate above the maximum ceiling configured, the second
parameter is the threshold in kbps for those rates.
Command
modes
This command operates in MPLS global adjustment threshold configuration mode.
History
Release
Command history
Multi-Service NetIron Release 05.6.00 The command was introduced.
Related
commands
None.